Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

Clutch Release Bearing Height

Started by italikko , Mar 06 2019 10:47 PM

Please log in to reply

4 replies to this topic

#1 italikko

Member

50 posts

Gender:Male
Location:Macedonia - The real and only

Posted 06 March 2019 - 10:47 PM

My previous clutch system was a lightweight single mass flywheel with helix disc.
It was working fine and had no slack on the pedal.
The full length of the system when I measure from flywheel bottom flat surface to the edge of the pressure plate tooth is 59.09mm.

The new clutch system i have picked for my build has a length of 50.94mm.
So it is 8.15 mm shorter.

Should I use a spacer for the clutch release bearing?

Edited by italikko, 06 March 2019 - 10:50 PM.

Back to top

#2 Johnboyhgt

Billy No Mates

1,311 posts

Gender:Male
Location:York
Interests:Girls, Tracks, Mods

Posted 07 March 2019 - 10:56 AM

is that clamped in place on the flywheel or just on the desk etc ?

Back to top

#3 italikko

Member

50 posts

Gender:Male
Location:Macedonia - The real and only

Posted 07 March 2019 - 11:18 AM

I have bolted both systems to the same flat surface.
Both systems where torqued to spec.

Edited by italikko, 07 March 2019 - 11:18 AM.

Back to top

#4 Johnboyhgt

Billy No Mates

1,311 posts

Gender:Male
Location:York
Interests:Girls, Tracks, Mods

Posted 07 March 2019 - 01:01 PM

I have bolted both systems to the same flat surface.
Both systems where torqued to spec.

Something not quite right there !!

Back to top

#5 italikko

Member

50 posts

Gender:Male
Location:Macedonia - The real and only

Posted 07 March 2019 - 02:10 PM

How it should be done?

The all the reference points are the same except the pressure plate tooth.

Back to top

Back to Tuning & Modifications

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

Community Forum Software by IP.Board
Licensed to: vx220.org.uk